 |
Email Enquiry |
|
|
Contact Information
Phone:
(713) 649-5310
(800) 200-3047
Fax:
(713) 649-5305
Mailing Address
Marco Specialty Steel, Inc.
P.O. Box 590643
Houston, Texas 77259-0643
Physical Address
Marco Specialty Steel, Inc.
6633 Lindbergh
Houston, Texas 77087 |
| |
|
|
|
|
Since Hex Metal's flexibility allows it to be rolled, it easily conforms to circular shapes. It is ideal for lining Ducts, Furnaces, Reactor Vessels, Cyclones, Flue Gas Lines and other high temperature equipment of virtually any shapes.
Flex metal is the direct counterpart of Hex metal, it performs all the same functions of reinforcement of thin wall refractory linings, its design however allows free form rolling to very small diameters. Hex metal becomes impractical to use when the section of plant being protected is of small diameter, the free rolling capabilities of Flex metal allows plant as small as 150mm to lined. Typical applications include Air Distributors, Cyclone Diplegs, Fan Cases, all plants where the practicality of free rolling material is beneficial to maintenance activities.
|
| |
Other Refractory/
Insulation Products: |
- Welded Mesh
- Tie Wire
- Chicken Wire
- Foil
- Knitted Mesh
|
| |
|
Armour-Anchors can be used in combination with Hexmetals / Flexmetals or as stand alone systems.
Wire Formed Anchors configured to suit all light, medium and dense refractories in providing maximum support during refractory application and maximum retention of
refractories during plant service. Consideration is given to expansion, heat transfer, method of application, environmental conditions and design of host unit for individual applications, standard designs are defined in our data sheet catalogue. Anchors are designed for Manual and Semi-Automatic Welding.
The range of applications is limited only by the structural strength of the anchor section. The maximum section size of wire formed anchors
is 3/8" (9.5mm). Typical applications include furnaces, ductwork, heaters, reactors; in fact, most process plant
Plate Formed Anchors are divided into Metallic Anchors and Ceramic Supports. The Metallic Anchors are designed typically for ceramic fibre and for light and medium weight refractories, again configured to provide maximum retention during plant service. The Ceramic Anchor Supports "C" Clips are designed to retain most standard pattern ceramic anchors (Scissor Clip types are available as wire formed) Mainly for light and medium weight duties, their typically small cross sectional area provides low heat transfer with section size providing ease of both manual and semi-automatic welding. "C" Clips retain ceramic anchors used for anchoring moldable refractories.
Rod Formed Anchors / Studs (larger than 3/8" diameter) Heavy weight anchors are used only in the most arduous conditions. They are designed to provide support and attachment of refractory pre-cast sections to plant steelwork, and provide an effective anchoring system in high stress situations. Their design shape minimizes and controls heat transfer and thus provides maximum strength and elevated temperatures. Refractory lining situations that have attendant high live loads such as Rotary Kilns; deep roof and side wall lining of dense refractories requiring maximum support during operating conditions; heavy weight pre-cast blocks retained by bolt through, weld on and slip on systems.
Call your Hex Metal specialist today! 1-800-200-3047
|
|
